LILYGO® TTGO 1/2Pcs LoRa32 V1.0 LoRa 868MHz 915MHz
⚠️Please note that all policy page on site only applies to items purchased from our store: https://www.lilygo.cc.
At present, the price of the platform does not include tax.
Customers in Europe should pay attention to the tax problem after the package reaches the local country.
[orders over 150 euros may generate tax, which needs to be borne/handled by the customer, the local policy shall prevail.]
People with programming foundation[engineers / students / makers, etc..]
Shipping & Delivery
Shipping & Delivery
Methods & Delivery Time
Standard Express: 25-30 Days
YunTu Express: 15-20 Days
DHL: 10-17 Days
FedEx: 10-17 Days
If you do not see one of the above shipping methods when checking out, it may be because your country does not support that shipping method, please select one of the available channels already listed or contact us for assistance.
Please note that all delivery times are estimated for reference only.
For more details please check our shipping policy.
LILYGO® TTGO 1/2Pcs LoRa32 V1.0 LoRa 868MHz 915MHz ESP32 Development Board OLED 0.96 inch Display Wireless Module WIFI Bluetooth
LoRa32 V1.0 Introduction
This product is a SX1276 chip based on ESP32 WIFI increased OLED, namely LoRa remote modem, 868-915MHz frequency, high sensitivity is over-148dBm, + 20dBm output power, high reliability, long transmission distance.
Onboard 4Mt bytes (32 Mt bit) Flash wi-fi antenna, 0.96 inch oled display, lithium battery charging circuit, support for Arduino development environment perfectly, can be used for program checking and product development is very easy and fast.
|Operating voltage: 3.3 – 7 V|
|Operating temperature range: -40 to 90°C (-40 to 194°F)|
|Support for Sniffer software protocol analysis, Station, SoftAP, and Wi-Fi Direct modes|
|Data rates: 150 Mbps @ 11n HT40, 72 Mbps @ 11n HT20, 54 Mbps @ 11g, 11 Mbps @ 11b|
|Transmit power: 19.5 dBm @ 11b, 16.5 dBm @ 11g, 15.5 dBm @ 11n|
|Receiver sensitivity up to -98 dBm|
|UDP sustained throughput: 135 Mbps|
|- The 868/915 MHz antenna needs to be connected with the IPEX interface.|
|- When the battery is full, the blue LED will stop working.|
|- When using, pay attention to “+” and “-” of the battery.|
|- With the IO port touchscreen Touch signal input, you need to add the 100nF pull-down capacitor to this pin.|
|- Red light: power indicator|
|- Blue light: IO25 programmable control|
|Reminder: This product does not include the battery.|
868/915MHz CH9102 1pcs Options
1 x LILYGO LoRa32 V1.0 (868MHz or 915MHz)
1 x Power cable (Jst 2pin 1.25mm)
1 x LoRa Antenna
2 X 2.54mm Male Pin（1*18P）
868/915MHz CH9102 2pcs Options
2 x LILYGO LoRa32 V1.0 (868MHz or 915MHz)
2 x Power cable (Jst 2pin 1.25mm)
2 x LoRa Antenna
4 X 2.54mm Male Pin（1*18P）